Automotive tools, specialty tools, mechanic tools, diagnostic scantools, and automotive equipment. Complete stock of major brands of industrial and automotive tools.
Complete stock of industrial tools and equipment for the construction trades such as generators, pressure washers, hoists, and others. On splitting the tractor I discovered a badly worn pilot bushing on the clutch shaft where it seats in the crankshaft.
Changed the bushing & throwout bearing. Same problem in Split the tractor and found the pilot bushing worn again and decided to check the rear of the clutch shaft. I found the clutch drive shaft joint disc bent nearly in. Mar 23, Thanks (0) Quote Reply Posted: at pm.
Pack the bushing cavity with grease, then drive a tool that just fits the ID of the bushing in, then,hydraulic pressure will push the bushing out. (You are referring to the clutch pilot bushing in the end of the crankshaft, right?) BOULDER 48 2A. Apr 27, Chevy Clutch Removal /assembly? Discussion in 'The Hokey Ass Message Board' started by Psycho Deville, Aug 3, from RI/MA.
black51chevy said and change the pilot bushing. I think if you search the hamb you might find some threads about ways to get it out of the crank.
Be careful with the flywheel bolts, make sure to fully bend over. Aug 20, Does anyone know how to remove the clutch pilot bushing from the back of the crank of a ? Is there a special tool for this? I removed a 3 speed tranny for a C4 and it didnt line up to the crank. This bushing is in the way and I dont want to reove the engine and dismantle it to remove this. Mar 26, Clutch pilot bushing removal question. Thread starter The Doge; Start date Mar 24,; The Doge Well Oiled. Jun 15, 1, Allen, TX.
Dec 02, Location: Bogalusa, La. Re: Clutch Pilot Bushing Removal - - Help.
Postby mvhighcrop» Mon Nov 29, pm. Get a 3/8" pipe tap (not a bolt tap) and thread it inside of the bushing. Keep turning until the tap bottoms out, then continue turning. May 07, I split my mowing Cub a few days ago to change the clutch and popped the Pilot bushing out with grease and a cut off transmission spline I use for clutch alignment Took a goodly amount of grease and a goodly amount of whacking but its a great way of removing the bushremove.buzz how my neighbor had a split to do today so I went over to help him When it came time to do the Pilot.